 
About Kurt Manufacturing
Your One Stop Advanced Technology Solutions Provider for Kurt Vises and Workholding Products
Mission Statement
By performing beyond expectations our customers are loyal, our employees are rewarded with expanded opportunities, the corporation is strengthened by profitable growth, and leadership is achieved
Quality Policy
Kurt Manufacturing is committed to customer satisfaction through continuous improvement.
The original Kurt Anglock® D-Series vises are designed for precision part clamping on basic machine tools such as knee-type mills, grinders and machining centers. D-Series vises are ideal for use in running production parts where datums, flatness and parallelism is important. You can precision bore, tap, drill, grind and finish with high accuracy on most parts made of die cast aluminum, steel, and iron in your Kurt Anglock vises. No other brand can give you the time proven accuracy of the Kurt Anglock vises. All Kurt vises have a friction reducing, needle bearing, thrust collar. The needle bearing increases jaw clamping pressure.
 Manual Vise 4" ---- D40
The D40 vise is recommended for intermediate milling and grinding work. It is an ideal vise for use in matched multiples for holding long parts. With jaw plates in their outside positions, this 4 inch vise has a capacity of 10-5/16 inches.
 Manual Vise 6" ----D688
The D688™ vise has a large 8.8" jaw opening. The machined rail allows precision alignment. The nut does not extend beyond the end of the vise body. Approximately a 20% increase in clamping pressure over the D675 vise. Powder coat paint resists coolant-induced peeling for greater corrosion protection.
 Manual Vise 8" ----D810
Kurt’s D810 vise has a large 10" jaw opening and a clamping force up to 11,600 lbs. The top down, four bolt design on the stationary jaw reduces vise deflection by 25% while allowing total disassembly of the vise without removing the body from the machine table. Special brush seals shield and protect vise screw threads from machined chips and residue. The nut has been shortened so as not to protrude past the end of the vise body. Powder coat paint resists coolant-induced peeling for greater corrosion protection. The overall vise footprint is identical to earlier models so both can be used interchangeably and in tandem. The D810 vise locks parts precisely including very large parts for aggressive “hogging out” operations.
 Manual Vise 10" ----D100
The D100 is the largest and strongest of our general purpose vises. With 9-3/4 inches of jaw opening it has the capacity and strength to take on your highest horsepower milling cuts. It’s the most precise and rugged 10 inch production vise in the world.
|
